page 8
10. Automated Learning Process./Activating Code.
Install 12-volt battery (provided) in transmitter and wall control (if applicable).
IMPORTANT
: Store the transmitter away from excess heat or humidity. To prevent damage to transmitter,
remove the battery if not used for long periods.
LED LIGHT:
Comes on when any button is pressed.
FAN
SPEED,
Buttons
1-6
:
Use to control the ceiling fan speed 1-6.
REVERSE
:
Use to control fan direction.
CODE SWITCHES
and
LEARN
button
:
With fan power OFF, set
CODE SWITCHES
on handheld remote control
and wall control to desired code setting. Turn fan power on. Within
30 seconds of powering fan, press and hold
LEARN
button on remote
control and/or wall control for 5 seconds (or until fan beeps twice) in
order to synchronize remotes with fan motor.
UP-LIGHT
:
Use for up-light (if applicable).
LIGHT KIT
:
Use for light kit (if applicable).
DIMMER SWITCH
:
Dimming capability is determined by the type of bulbs provided with
the light kit.
ON position =
D
OFF position =
O
FAN OFF:
Use to turn fan off.
ON
/
OFF
slider switch:
[
Wall control only
] Use to turn wall control on or off.
Select faceplate for remote control and/or wall control and press firmly onto front of remote control/wall control.
IMPORTANT
:
The Automated Learning Process takes 5 minutes to complete. Please leave the fan “on”
for the duration of the 5-minute programming and do NOT use the remote control during
this time.
REMOTE
CONTROL
12
3
4
D
12V
ON
O
UP LIGHT
LIGHT KIT
FAN OFF
REVERSE
1
2
3 4
5
6
1
2
3
4
5
6
LEARN
WALL
CONTROL
12
3
4
D
ON
O
DIMMER
SWITCH
IMPORTANT:
Remote and wall
controls must be
SYNCHRONIZED with
fan in order to
properly function.
IMPORTANT:
The code switches in
remote and wall
controls MUST MATCH
for fan to function
properly.
UP LIGHT
LIGHT KIT
FAN OFF
REVERSE
ON/OFF
SLIDER
SWITCH
CODE
SWITCHES
LEARN
CODE
SWITCHES
DIMMER
SWITCH
FAN SPEED
FAN SPEED
LED LIGHT
LED LIGHT
12V
