page 9
grooves
nodules
dimmer
switch
wall control
wire
wire
wire
12V battery
10. Handheld Remote Control
Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do
not
wish to
use the handheld remote control, please proceed to
Section 11.
Gently pull on remote control cover to separate
top and bottom parts.
[
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was
not previously used)--use wire cutters to cut off
each wire as close to the wall control as possible.
[
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall
control.
[
Refer to
diagram 2
.
]
The dimmer switch (labeled
ON
and
D
) has been
pre-set to the "ON" position (
ON
). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (
D
).
[
Refer to
diagram 2
.
]
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom.
[
Refer to
diagram 3
on the
next page.
]
[”Handheld Remote Control Assembly"
continued on next page.]
(top)
(bottom)
remote control
cover
diagram 1
diagram 2
I
II
IV
VI
III
V
9. Light Kit Assembly. (cont.)
If you do NOT wish to use the light kit
,
locate
slots on metal cover and align with nodules
inside
LED light kit
. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
until it
no longer turns.
WARNING
: D
o
NOT
connect the molex
connections for the LED light kit if you do NOT
wish to use the light kit.
WARNING
: Metal cover will be HOT if light is left
on.
metal
cover
