page 10
It is recommended that you test fan before
finalizing installation. Locate ON/OFF slider switch
on wall control and set to the ON position. Test
light and dimmer function and then test fan
speeds. Next, locate remote control transmitter.
Test fan speeds with the different fan speed
buttons on remote control. Test the light ON/OFF
function with the button on the remote control.
Test dimmer function by holding down the
button for more than 2 seconds. (
diagram 1
) If the
remote control operates all of the functions of the
fan and light, battery has been installed correctly. If
fan and/or light do (does) not function, please refer
to "Troubleshooting" section to solve any issues.
Turn fan completely off
before
moving the reverse
switch (located on top of motor housing). Set
reverse switch to recirculate air depending on the
season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
NOTE
: If the remote control interferes with other
appliances, change code switches on the
transmitter to another code. If you do change the
code,
turn power off first
, remove the battery
cover, and, after setting the new code, go back to
the instructions in the last paragraph of Section 10
(page 9).
12. Remote Control Operation.
HI
button - turns fan to HIGH speed
MED
button
- turns fan to MEDIUM speed
LOW
button
- turns fan to LOW speed
OFF
button
- turns fan OFF
button - controls LIGHT function: turns light
ON/OFF when tapped quickly. Pressing and
holding button down for more than 0.7 seconds
converts it into a dimmer. Auto resume capability
keeps light at same brightness level as the last
time it was turned off.
reverse switch
13. Testing Your Fan.
diagram 1
diagram 2
diagram 3
diagram 4
motor
housing
(
topside
)
remote control
transmitter
wall
control
