page 4
NOTE
: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
5. Fan Assembly (with downrod).
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
4in. downrod provided to use with an extended
downrod (sold separately). [
If you wish to use the
4in. downrod, please proceed to instructions
following the dotted line below.
]
To remove hanging ball, loosen set screw on
hanging ball and remove pin and clip. Lower
hanging ball and remove stop pin. Slide hanging
ball off the original downrod, A, and slide it down
the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use
this hole when setting the set screw). Insert stop
pin into top of extended downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely.
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from downrod (if
you have not already done so). Slide downrod
through canopy and yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the
downrod.
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. Lower canopy to motor housing.
["Fan Assembly" continued on next page.]
yoke set screw
downrod
electrical wiring
pin
clip
canopy
motor
housing
yoke cover
B
set screw hole
set screw
hanging ball
stop pin
pin
clip
A
