page 11
11. Automated Learning Process./Activating Code.
wall control
faceplate
(almond
or white)
I
II
IV
VI
III
V
OFF
ON
SET button
faceplate
(black)
handheld
remote control
I
II
IV
VI
III
V
OFF
ON
SET button
diagram 1
diagram 2
CAUTION
:
The wall and/or handheld remote control
can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall
control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall
control, press and hold the fan
SET
button on the
wall control for 5 seconds or until light blinks
twice.
Turn power off again for at least 5 seconds
and
then turn power back on. Within 60 seconds of
restoring the power, press and hold the fan
SET
button on the handheld remote control for
5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--
see Section 13 on the
following page.
Select a faceplate (
almond or white
) and press
firmly onto front of wall control that was previously
installed to the outlet box on the wall. [
Refer to
diagram 1
.
]
Attach
black faceplate
to front of handheld remote
control; press down firmly. [
Refer to
diagram 2
.
]
