Craftmade Eastwood EAS60, Руководство по установке

Страница: 10 / 36

page 10
10. Handheld Remote Control Assembly. (cont.)
( NOTE : Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and bottom
of remote control cover together until you hear a click
at each end, indicating that the remote control cover
has closed completely.
IMPORTANT : Store the handheld remote control away
from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if
remote control will not be used for long periods.
CAUTION : “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When disposing
of household alkaline batteries, it is best to check with
your local and state recycling or household hazardous
waste coordinators concerning the specifics of the
program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or 1-877-2-RECYCLE
or visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING : Choking Hazard - Small parts. Keep
battery away from children.
wall
control
remote control
cover, BOTTOM
post
hole
post hole
remote control
cover, TOP
I
I I
IV
VI
I I I
V
11. Automated Learning Process./
Activating Code.
wall control
faceplate
(almond
or white)
I
I I
IV
VI
I I I
V
OFF ON
SET button
faceplate
(black)
handheld
remote control
I
I I
IV
VI
I I I
V
OFF ON
SET button
CAUTION : The wall and/or handheld remote control
can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall
control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall
control, press and hold the fan
SET button on the
wall control for 5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds and
then turn power back on. Within 60 seconds of
restoring the power, press and hold the fan
SET
button on the handheld remote control for
5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--
see Section 13 on the
following page.
Select a faceplate ( almond or white ) and press
firmly onto front of wall control that was previously
installed to the outlet box on the wall.
Attach black faceplate to front of handheld remote
control; press down firmly.
diagram 3