page 7
*Blade drawings in this manual are representative
only.
9. Switch Housing Assembly.
Loosen 3 screws on fitter plate (on underside of
motor housing). Align slotted holes in top of
switch housing with loosened screws in fitter
plate. Twist switch housing to lock. Securely
tighten all 3 screws.
switch
housing
fitter
plate
motor housing
8. Blade Assembly.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Time Saver
: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
(
sold separately
) and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws/lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
).
NOTE
: Additional
blade arm screws are located in one of the
hardware packs.
Align blade arm holes with motor screw holes
and attach blade arm with blade arm
screws/lock washers. Before securing screws
permanently, repeat with remaining blade arms.
Securely tighten all screws.
NOTE
: Tighten blade arm screws twice a year.
blade arm
blade
blade attachment
screws and washers
lock washers
blade arm screws/
motor housing
plastic
motor
lock
