page 10
10. Light Kit Assembly (Optional). (cont.)
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF position
(no blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull will
set the fan to LOW. Fourth pull will again set the fan to
the OFF setting. Test light with the pull chain in the
middle. (diagram 1) If fan and/or light do (does) not
function, please refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch (located on the switch housing). Set reverse
switch to recirculate air depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chain extension(s) supplied or custom pull
chain extension(s) (sold separately) to end(s) of the
pull chain(s).
11. Testing Your Fan.
Remove finial, finial plate, hex nut, flat washer
and rubber washer from threaded rod at
bottom of light kit fitter. Place rubber washer
inside shade over center hole. Raise shade in
order to guide pull chains through appropriate
holes in shade. Align threaded rod on light kit
fitter with hole in middle of shade and push up
gently, allowing threaded rod to come through
hole. (Be sure pull chain for fan operation does
not rub against bulb during operation.)
Replace flat washer and hex nut on threaded
rod. Tighten hex nut to secure shade, but DO
NOT OVERTIGHTEN hex nut as shade may crack or
break. Align hole in center of finial plate with
threaded rod, allowing pull chains to come
through appropriate holes in finial plate, and
push up. Thread center pull chain through hole
in finial and secure shade to light kit fitter by
tightening finial. DO NOT overtighten finial as
shade may crack or break.
light kit fitter
switch
housing
pull chain
extensions
pull chain
for fan
reverse
switch
finial plate
flat washer
hex nut
rubber washer
diagram 2
diagram 3
diagram 4
diagram 1
motor housing
finial
shade
pull chain
for light
