Craftmade Cronus CRO52, Руководство по установке

Страница: 6 / 22

page 6
safety cable
5. Fan Assembly. (cont.)
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop
pin. Then slide hanging ball off downrod.
[ Refer to
diagram 1 . ]
Loosen yoke set screws and nuts at top of motor
housing.
[ Refer to diagram 2 . ]
Tip : To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
[ Refer to
diagram 2 . ]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[ Refer to diagram 2 . ]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get twisted .
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely.
[ Refer to diagram 2 . ]
Slide yoke cover, canopy cover and canopy over
downrod.
[ Refer to diagram 3 . ] ( Note : Canopy
cover must be turned with shiny side toward the
motor housing.)
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely.
[ Refer to diagram 4 . ] Lower
yoke cover to motor housing.
WARNING : Failure to tighten set screw
completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
downrod
electrical wiring
canopy
yoke cover
motor
housing
diagram 2
diagram 1
diagram 3
diagram 4
set screw hole
hanging ball
stop pin
downrod
electrical wiring
yoke set screw
and nut
pin
clip
motor
housing
set screw
hanging ball
stop pin
pin
clip
safety cable
canopy cover