page 9
10. Handheld Remote Control Assembly.
(top)
(bottom)
remote
control
cover
diagram 1
1
1
-
ON/ DIM
OFF
wall
control
face-
plate
remote control
cover,
BOTTOM
post
hole
diagram 3
post
hole
remote control
cover,
TOP
2
2
-
dimmer
switch
wall control
wire
wire
wire
1
1
-
ON/ DIM
OFF
12V battery
diagram 2
2
2
-
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the
wall control but do
not
wish to use the handheld remote
control, please proceed to Section 11.
Gently pull on remote control cover to separate top
and bottom parts. [
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each wire
as close to the wall control as possible. [
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall control.
[
Refer to
diagram 2
.
]
Since this fan comes with a LED light kit, the dimmer
switch (labeled
DIM
and
ON
) has been pre-set to the
"ON" position (
DIM
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
ON
). [
Refer to
diagram 2
.
]
Attach
black faceplate
to front of wall control; press
down firmly. [
Refer to
diagram 3
.
]
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and press
together firmly. Place wall control into BOTTOM part of
remote control cover, aligning posts in top of remote
control cover with post holes in the bottom. [
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and
bottom of remote control cover together until you
hear a click at each end, indicating that the remote
control cover has closed completely.
IMPORTANT
: Store the handheld remote control away
from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if
remote control will not be used for long periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When disposing
of household alkaline batteries, it is best to check with
your local and state recycling or household hazardous
waste coordinators concerning the specifics of the
program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or
1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep
battery away from children.
