page 7
9. Light Kit Assembly (Optional). (cont.)
Punch center cap out of switch housing cap with a
screwdriver. Remove the hex nut and lock washer
from threaded rod at top of light kit fitter. Feed wires
from light kit fitter through center hole in switch
housing cap. Then, screw switch housing cap onto
threaded rod on light kit fitter followed by lock
washer and hex nut. Tighten hex nut over lock
washer for a secure fit.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from switch housing. Connect
BLACK
wire from
light kit fitter to
BLUE
(or
BLACK
) wire from switch
housing. Be sure molex connections snap together
securely.
Align holes in switch housing cap with holes in
switch housing. [
NOTE:
Gap on edge of switch
housing cap must align with reverse switch in switch
housing for proper fit.] Re-insert screws that were
previously removed. Securely tighten all 3 screws
with a Phillips screwdriver.
Install 2 medium base compact fluorescent 13 watt
bulbs (included).
IMPORTANT
: When replacing bulbs, please allow
bulbs and glass shade to cool down before touching.
Remove finial, finial plate, hex nut, spring washer and
rubber washer from threaded rod on light kit fitter.
Place rubber washer inside glass shade over center
hole. Raise glass shade in order to guide pull chains
through corresponding holes in glass shade. Align
threaded rod on light kit fitter with hole in middle of
glass shade and push up gently, allowing threaded
rod to come through hole. (
Be sure pull chain for fan
operation does not rub against bulb during operation.
)
Replace spring washer and secure glass shade with
hex nut that was previously removed.
Do NOT
overtighten hex nut as glass may crack or break.
Thread pull chains through corresponding holes in
finial plate, allowing threaded rod to come through
hole in middle of finial plate, and push up. Thread
center pull chain through hole in finial and re-attach
finial.
Do NOT overtighten finial as glass may crack or
break.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
hex nut
lock washer
light kit
fitter
switch housing
cap
hex nut
lock washer
bulb
threaded rod
light kit fitter
glass
shade
switch
housing
cap
finial
finial plate
rubber
washer
switch
housing
molex
connections
pull chain
for fan
center
cap
spring washer
hex nut
