page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
canopy
screw
hanging bracket
screw
8. Blade Assembly.
Time Saver
: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat with
remaining blade arms. Securely tighten all screws.
Note
: Tighten blade arm screws twice a year.
blade attachment
screws and washers
motor housing
blade arm
blade
plastic
motor lock
blade arm screws
lock washers
9. Light Kit Assembly (Optional).
If you wish to use your fan WITHOUT the light kit
,
please proceed to Section 10 on page 8 to complete
installation WITHOUT the light kit.
If you wish to use fan WITH the light kit
, remove
3 screws from switch housing and remove switch
housing cap.
Locate
BLUE
(or
BLACK
) and
WHITE
wires in switch
housing labeled FOR LIGHT. Remove and discard
plastic that holds these two wires together.
["Light Kit Assembly" continued on next page.]
switch
housing
switch housing cap
white wire
blue (or
black) wire
motor
housing
