page 7
9. Light Kit Assembly, 1-light Options.
glass
shade
bulb
light kit fitter
switch
housing
fan pull chain
reverse
switch
black wire
blue
(or black)
wire
white
wire
molex
connections
white wire
finial
finial plate
threaded washer
Remove 3 screws from switch housing cap (at
top of light kit fitter).
Locate
BLUE
(or
BLACK
) and
WHITE
wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic that
holds these 2 wires together.
Connect
WHITE
wire from switch housing to
WHITE
wire from light kit fitter. Connect
BLUE
(or
BLACK
) wire from switch housing to
BLACK
wire from light kit fitter. Be sure molex
connections snap together completely.
Align holes in switch housing cap with holes in
switch housing. (
NOTE
: The gap on the edge of
the switch housing cap must align with the
reverse switch on the switch housing for the
proper fit.) Re-insert screws that were
previously removed. Securely tighten all 3
screws with a Phillips screwdriver.
Install bulbs included with light kit.
IMPORTANT
: When you need to replace bulbs,
please allow bulbs and glass shade to cool
down before touching them.
Remove finial, finial plate and threaded washer
from threaded rod on light kit fitter. Raise glass
shade in order to guide pull chains through
appropriate holes at bottom of glass shade.
Align threaded rod on light kit fitter with hole
in middle of glass shade and push up gently,
allowing threaded rod to come through hole.
(
Be sure pull chain for fan operation does not rub
against bulb during operation
.) Secure glass
shade with threaded washer.
Do NOT
overtighten threaded washer as glass may crack
or break.
Align hole in center of finial plate with
threaded rod, allowing pull chains to come
through appropriate holes in finial plate, and
push up. Thread center pull chain through hole
in finial and re-attach finial.
Do NOT overtighten
finial as glass may crack or break.
Please proceed to Section 11 on page 10 to
complete installation.
switch housing
motor housing
switch housing cap
light kit fitter
molex
connections
*For
Models C201
and
C202
follow instructions on this page.
*For
Model C209
, proceed to instructions on page 8.
