page 9
10. Light Kit Assembly.
Remove 1 screw from motor plate (on underside
of motor housing) and partially loosen the other
2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from LED light kit. Connect
BLACK
(or
BLUE
) wire from motor housing to
BLACK
wire from LED light kit. Be sure molex
connections snap together securely.
Align slotted holes in LED light kit with loosened
screws in motor plate. Carefully arrange wiring
within space in LED light kit so that wires remain
completely inside LED light kit. Twist LED light
kit to lock. Re-insert screw that was previously
removed and secure all 3 screws with a Phillips
screwdriver.
Align slots on glass shade with nodules on
underside of LED light kit.
Push up gently on
glass shade and turn glass shade
to the RIGHT
(clockwise)
until it slides completely into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
11. Assembly of Handheld Remote Control.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 11
for remote control assembly instructions. If you
have already installed the wall control but do
not
wish to use the handheld remote control, please
proceed to Section 12.
Gently pull on remote control cover to separate
top and bottom parts.
[
Refer to
diagram 1
.
]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible.
[
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall
control.
[
Refer to
diagram 2
.
]
Since this fan comes with LED light kit, the
dimmer switch (labeled
DIM
and
ON
) has been
pre-set to the "ON" position (
DIM
). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (
ON
).
[
Refer to
diagram 2
.
]
["Assembly of Handheld Remote Control"
continued on next page.]
(top)
(bottom)
remote control
cover
diagram 1
dimmer
switch
wall control
wire
wire
wire
12V battery
1
1
-
2
2
-
DIM ON
diagram 2
glass shade
slots
motor plate
molex
connections
LED light kit
