page 11
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF
slider switch on wall control, then set to the ON
position. Test light and dimmer function and then
test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by
pressing the L1 button; test the dimmer function
by pressing the L1 button and holding it down for
up to 5 seconds. Test fan speeds with the
different fan speed buttons. If the wall and/or
handheld remote control operate(s) all of the
functions of the fan and light, battery/batteries
has (have) been installed correctly. If the wall
and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Fan
must
be on LOW
before
setting the fan to
reverse direction. Use "reverse" button (
REV
) to
recirculate air depending on the season.
NOTE
: If the wall control/handheld remote
control interferes with other appliances,
turn off
the power first
and then go back to the
instructions in Section 12 (page 10).
14. Testing Your Fan.
1
1
-
2
2
-
motor housing
13. Remote Control Operation.
1
1
-
2
2
-
wall control
1
1
-
2
2
-
handheld
remote control
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld
remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button - turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
L2
button -
(not applicable for this fan)
REV
button - used to REVERSE blade direction
(fan must be set on
low
before
reversing
blade direction)
