OPERATING INSTRUCTIONS - cont
SAFETY INFORMATION
• This machine should only be used by trained operators.
• Do not use this machine unless it is in a safe condition.
• Check the cable and plug for damage before use and if necessary replace with a new
cable pack.
• Only use Craftex approved cable from our distributors or direct.
• To stop the machine release on/off switches whilst holding on to the handle.
• Always pay attention to the cable and keep it away from the drive board/brush and
hot air blower – hazard may occur if the machine runs over the cable.
• Always work within the cable length to avoid cable stress or damage.
• Never use dirty pads and do not allow the pads to become over soiled before changing.
Always remove the drive board/brush before storing the machine.
• The machine has been designed for use with the drive boards/brush supplied by Craftex
– the fitting of other boards may affect its safety – for a guide to different board types
and their intended use – refer to the Craftex Thermadry Machine leaflet.
• Check that the voltage shown on the serial number plate is suitable for the supply
available.
• Only use an outlet socket for its intended purpose (exhauster attachment).
• Instructions for use of exhauster attachment supplied with exhauster.
• The Craftex Thermadry Machine maximum A-weighted sound pressure level Lpa
measured in dB (A) is less than 85dB (A).
• The maximum r.m.s acceleration value of a Craftex Thermadry Machine which
operators are subjected to = 1.5m/s2.
• Always remove plug from socket outlet before carrying out any routine maintenance.
THIS FLOOR MACHINE IS FITTED WITH A CIRCUIT BREAKER
• If the machine is overloaded the circuit breaker will trip out.
• The reset button can be depressed after 30 seconds to restart the machine.
• Caution: Before re-setting check:
• The Pad (if a Drive Board is used) is clean – if not turn or change pad.
• The brush is not too worn or clogged up.
• There are no cable or supply faults.
• Warning! This appliance must be earthed.
• Important: Wires in the mains lead are coloured in accordance with the following code:
• Green & Yellow = Earth
• Blue = Neutral
• Brown = Live
• As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug – proceed as follows:
• The wire which is coloured Green and Yellow must be connected to the terminal in the
plug which is marked with the letter E or by the Earth symbol or coloured Green or
Green and Yellow.
• The wire which is coloured Blue must be connected to the terminal which is marked
with the letter N or Coloured Black.
• The wire which is coloured brown must be connected to the terminal which is marked
with the letter L or coloured Red.
• A
Содержание thermadry
Страница 1: ...Instructions for use ...
