Craftex CX801, Руководство пользователя, Страница: 14 / 19

14
ALIGNMENT BETWEEN
CENTERS
The center alignment has been adjusted
properly at the factory before the machine
is shipped to you. However, after lengthy
operation, the centers may be out of
alignment. At this time center alignment
needs to be done.
TO ALIGN THE CENTERS:
Make sure the cord is disconnected from
the power source.
Remove tool rest base and the tool rest
and slide the tailstock with the center
towards the headstock.
Loosen the four screws securing the
headstock to the bed. Slightly adjust the
headstock position so that the centers are
aligned with each other.
Figure-15 Headstock and tailstock centers
aligned
MAINTENANCE
During the life of your machine, you will
need to practice some regular
maintenance to keep your lathe in peak
performance condition,
Check your lathe daily for loose mounting
bolts, damaged cord, worn switch and any
other unsafe condition.
CLEANING
1. Everyday after use, remove chips from
the machine and clean it. Apply oil on
the sliding surfaces.
2. Everyday after use, turn OFF the
power switch and remove the switch
key.
3. A build up of dust in the motor can
cause motor damage. Periodic
cleaning of the motor is not only
recommended, but mandatory for
normal wood lathe performance.
WARNING
Make sure the machine is turned OFF
the cord is disconnected from the
power source before servicing and
removing/replacing any components of
the machine.