Craftex CX704, Руководство пользователя

Страница: 18 / 27

18
Every day, after the operation, eliminate all
the chips and clean different parts of the
machine tool and apply machine tool oil to
prevent from rusting.
Good housekeeping practice should be
followed on a daily basis keeping your lathe
clean and well lubricated.
LUBRICATION
Lubricate all slide ways of the lathe bed,
compound slide and cross slide lightly
before every use using 10-30W oil or
similar.
The change gears, cross slide and
compound slide lead screws must also be
lightly lubricated with lithium based grease
after every 6 months.
Lubricate the transmission gears using
lithium based grease every year. To
lubricate the transmission gears, disconnect
the cord from the power source and remove
the front control panel, remove the ground
wire from the headstock and spray grease
in the hole. Rotate the chuck with your hand
and shift the gears high to low.
GIBS ADJUSTMENT
The cross slide and the compound slide
gibs will need to be adjusted after
sometimes.
TO ADJUST THE CROSS-SLIDE AND
COMPOUND SLIDE GIBS:
Disconnect the cord from the power source.
Loosen the lock nuts on the set screws
shown in figure-20.
Figure-20 Cross slide and compound slide
gibs adjustment screws
Tighten or loosen the set screws as
required and check the sliding movement of
the cross slide / compound slide. It should
move smoothly without any play.
Once the set screws are adjusted, tighten
the lock nuts to secure the set screws in
position.