Craftex CX119, Руководство пользователя, Страница: 15 / 29

15
Figure-19 Adjusting the table at 90° to the
table using square
Once the table is at 90°
with the blade,
tighten the hex nut and the knobs.
TABLE TILT SCALE
CALIBRATION
To calibrate the table tilt scale:
Make sure the table is at 90° and the blade
tensioning and tracking is properly done.
Disconnect the machine from the power
source and loosen the pointer screw shown
in figure-20. Align the tip of the pointer with
the 0” mark on the tilt scale and tighten the
pointer screw.
Figure-20 Table tilt scale
TABLE ALIGNMENT
To make accurate cuts with your band saw,
the table should be aligned properly with
the blade.
TO ALIGN THE TABLE:
Make sure the blade tension and tracking is
done correctly. Disconnect the machine
from the power source and loosen the two
knobs under the table. Place a straightedge
on the table so that the straightedge
touches the blade and is parallel to it as
shown in figure-21. Make sure the
straightedge touches only the flat part of the
blade, not the teeth.
Now, use a ruler to measure the distance
between the miter slot and the straight edge
on both sides on the table R & L. See
figure-21.
Adjust the table until the distance on both
sides of the table is equal and tighten the
knobs.
Figure-21 Aligning the table with the blade
using a straightedge