Craftex CX119, Руководство пользователя, Страница: 14 / 29

14
Use a proper size Allen key and loosen the
screws located on each of the two guide
bearings. Turn the knurled knobs on each
bearing to adjust the distance between the
bearing and the blade. Once the distance is
set, retighten the set screws. See figure-16.
Figure-16 Adjusting the guide bearings
Figure-17 Guide bearings distance from the
blade
Now, loosen the thumb screws shown in
figure-18 and move the bearing shafts in or
out so that the two guide bearings are 1/32”
behind the blade gullets and the thrust
bearing (upper bearing), 1/64”.
Figure-18 Distance of the bearings behind
the blade
Once the bearings are at the correct
position behind the blade, tighten the thumb
screws to lock the bearings in place.
Adjust the lower support bearings in the
same manner
.
TABLE STOP
ADJUSTMENT
CX119 features a table stop which allows
the table to easily come to a 90° if the table
is tilted.
To adjust the table stop so that the table
sits at 90°, you should first make sure the
switch is in “OFF” position and the power
cord is unplugged. Loosen the two lock
knobs under the table and loosen the hex
nut which locks the table stop bolt.
Now, place a square on the table as shown
in figure-19 and adjust the table stop so that
the table is at a 90° with the blade.
IMPORTANT!
Adjust the two guide bearings so that the
space between each bearing and the
blade should be 0.002” which is
thickness of a sheet of paper. See figure-
17.