Craftex CX112, Руководство пользователя

Страница: 8 / 18

- 6 -
F. To avoid injury from accidental starting,
always unplug saw before
disconnecting the guard, installing or
removing any blade, accessory or
attachment, or making any adjustment.
G. To avoid an electrical shock, make
sure your fingers do not touch the
metal prongs on the plug when
inserting or removing the plug to or
from a live outlet.
H. Never put lubricants on the blade while
it is spinning.
I. To avoid burns or other fire damage,
never use the saw near flammable
liquids, vapors or gases.
Whenever Saw is Running
WARNING:
Do not allow familiarity (gained
from frequent use of your metal saw) to
cause a careless mistake. Always
remember that a careless fraction of a
second is enough to cause a severe injury.
1. Before actually cutting with the saw, let it
run for a while. If your saw makes an
unfamiliar noise or if it vibrates excessively,
stop immediately. Turn the saw off. Unplug
the saw. Do not restart until you find and fix
the problem.
2. Never confine the piece being cut out.
Never hold it, clamp it, touch it, or use
length stops against it. It must be free to
move sideways. If confined, it could get
wedged against the blade and thrown
violently.
3. Avoid awkward hand positions where a
sudden slip could cause a hand to move
into the blade.
4. Let the blade reach full speed before
cutting.
5. Feed the saw into the work piece only fast
enough to let the blade cut without bogging
down or binding.
6. Before freeing jammed material, turn the
switch off and unplug the saw. Wait for all
moving parts to stop.
7. After finishing a cut, keep holding the power
head down, release the switch, and wait for
all moving parts to stop before moving your
hands.
WARNING
Read the fo llowing war ning labels found on
the front of the saw.
DANGER
․
Keep hands out of saw blade path.
․
Never cut anything freehand.
․
Never reach behind or beneath blade.
․
To avoid electric shock, do not expo se to
rain.
DANGER
․
Tighten arbor screw and all clamps
before turning power on.
Saw Safeguard - Pad Lock
To prevent the band saw from unauthorized
operation and to avoid accidental starting by
children or others not qualified to use, the use of
padlock is required. To lock out the on-off switch,
open the padlock, insert through the hole of the
switch cover and close the padlock. Place the
key in a location that is inaccessible to children
and others not qualified to use the tool.
Blade teeth selection and speed
recommendation
The following photo is not expected to be exactly
correct for all cases. It is intended as a general
guide to good sawing practices. Your blade
supplier or the qualified engineers should be your
most reliable source of correct information for
operational details of saw blades and their use.
Padlock