Craftex CX112, Руководство пользователя

Страница: 10 / 18

- 8 -
Fig. 4
Item Attached Parts Q’TY
1 Stop Rod Assembly (E) Fig.4 1set
2 Instrution Manual 1
6. Description and Characteristics
1. This CX112 portable band saw is made as
light as 23 kg by weight allowing easy
transport to any worksites.
2. Th e machine frame is cast aluminum.
The base is formed by the steel so
that body construction becomes stronger
and smoother.
3. During operation, the noise level of th e
machine is about 60 db, which is much less
than any of the other band saws, and of
course, it features a comfortable
working environment.
4. This machine features easy blade tension
adjustment . Hold the handle to
give a little turn for the tension increasing,
or decreasing as you wish while changing
blade or when the machine in operation.
It a lso has compression spring attached
which is for reducing vibration produced when
cutting defective work piece .
It permits the blade to be used much longer.
5. The drive of this machine is through gear
transmission that gives steadier, stronger,
and smoother cuts superior to any of pulley
drive band saws, and make less trouble
after service. Note: If anything unusual
happens on your gear transmission system,
do not try to fix or restore it personally.
Send it back to your dealer for check-up or
repair. Failure to comply can result in
machine damage.
6. The machine combines miter, and
horizontal cutting and is designed for full
efficiency and operator 's convenience in
each position.
WARNING
SHUT OFF THE POWER SOURCE ALL THE
TIME, BEFORE THIS MACHINE IS IN
MAINTENANCE, OPERATION, ADJUSTMENT,
OR REPAIRMENT.
WARNING
Disconnect machine from the power source!
No matter when, where, or how. Pay extra
attention to the saw during it in transportation,
operation, maintenance, or adjustment.
Failure to comply may cause serious injury!
7. Operating
Information before Operation
Be sure the blade isn’t in contact with the work
when the motor is started.
Run the motor allow the saw to come to full
speed. Begin the cut by letting the head down
slowly onto the work.
DO NOT DROP. Use the handle of trigger switch
operating by hand.
Press green button down (Fig. 5) to turn on the
power and press and hold the trigger switch
(Fig.6) for manual cutting.
Finish cutting or stop the cutting by press
ing
down the red button or release the trigger
switch.
Fig. 5
Fig. 6
Trigger switch
E
ON/OFF switch