Craftex CT171, Руководство пользователя

Страница: 9 / 15

9
Figure-3 Checking the grinder wheel
surface parallelism with universal support
TEST RUN
Once you have assembled and inspected
the machine it is then time to do a test run
and see if the machine powers up and runs
properly.
All the tools and objects used for
assembling the machine should be
removed and cleared away during test run.
Connect the machine to the correct power
source and start the machine. During the
test run if there is any unusual noise or
vibration, disconnect the machine from the
power source immediately. Check all the
parts you have assembled, once again and
try to find out the problem.
During the test run make sure the start/stop
button and all the safety features on the
grinder are working properly.
WATER RESERVOIR
The CT171 is a wet grinder and is equipped
with a water reservoir. Do no attempt to
perform grinding on this machine without
water. If the grinder is used without water, it
will either damage the grinding wheel or the
tool you are grinding.
The water reservoir is equipped with
mounting tabs used to hook to the slots on
the grinder body.
The water reservoir can be attached to the
lower slots of the grinder body when the
grinder is not in use while it is attached to
the upper slots, (filled with clean water)
when in use.
Make sure not to keep the grinding wheel
inside the water when the grinder is not
used for a long period of time. Failure to do
so, can cause the wheel become
unbalanced and break off easily while
grinding. The reservoir should be emptied
and attached to the lower mounting slots
when the grinder is not used.
Figure-4 Installing the water reservoir
WARNING
Do not make any adjustments while the
machine is running. Turn the machine
OFF and un-plug from the power source
before making any adjustments. Failure to
do so may cause serious personal injury.