Craftex CT015N, Руководство по эксплуатации

Страница: 16 / 35

16
STEP FOUR (continued)
4. Mount the main pulley drive (the wheel drive pulley) (#158), the smaller of the
two pulley drives, face in to the drive shaft. Insert the key and tap in it with a
rubber mallet.
5. Mount the lower pulley drive (the idler pulley) (#162) face out and push it in as far
along the shaft as it will go. Insert the key and tap it in with a rubber mallet.
6. Slip on the small drive belt (the speed selector belt) (#159A) and adjust both the
wheel drive pulley and the idler pulley so that the belt runs straight between
them. Tighten the setscrew for the wheel drive pulley.
7. Slip on the large drive belt (#161A) so that it runs between the idler pulley and
the motor pulley. It is necessary to tilt up the motor from below so that the belt fits
over the motor pulley. Make sure the belt is not touching the edges of the slot in
the stand table; adjust the motor pulley (and the idler pulley, if necessary) in or
out so that the belt runs straight. If required, readjust the wheel drive pulley per
above step (loosen its setscrew first). Tighten the setscrews on the drive pulley
and the motor pulley.