Craftex B2470, Руководство пользователя

Страница: 8 / 16

B2470 Tile Saw
Installing the Water Supply
To prevent excessive wear on the blade be sure to maintain a continuous
flow of water over the blade while cutting. Never cut anything if the water
flow is not continuous.
1. Attach the pump as described in step 4, “ Assembly”. Position the
pump so it will not interfere with the motion of the table while cutting.
2. Fill water tank with enough water so that the pump is completely
submerged but not so much water that the tank overflows.
Note: When using the tile saw extreme care must be taken to insure that
the saw’s power cord is positioned to remain dry and free from water at all
times. Severe personal injury or death can occur it the power cord or the
operator of this tool should become wet at any time while this tool is in
use. Care and common sense must be used in planning a safe work area.
Operation
Preparing to Cut:
1. Place your marked tile to the side for a moment.
2. Fill tank with water as described in Installing the water supply above.
3. Plug the pump’s power cord into power unit. Make sure the pump
power cord is positioned so it will remain in a dry location once the
machine is in use.
4. When it is safe to do so, plug the power unit cord into the appropriate
power source.
5. Put on approved eye protection.
6. Flip the power switch located on the front of the motor to the on
position.
7. Before operating the tile saw let the motor run for approximately one
minute. Make sure the blade is operating at full speed and there are no
unusual noises. If you feel the unit is not operating properly do not use.
8