Crafco EZ 500 Series II, Руководство пользователя

Страница: 36 / 136

EZ 500 Series II Melter Part Manual
Chapter 5 Operating Instructions
©2019 by Crafco, Inc. All Rights Reserved………………..…………………………………..….Operating Instructions 5-14
5.12 Overnight Heaters
Overnight heaters may be used to maintain an overnight heat transfer oil temperature of
approximately 200-250°F (93.3°C)
Step Action
WARNING
The overnight heaters are for overnight use only. If the overnight heater is used, the
material must be dispensed the next day. If the material can't be dispensed, the
machine needs to be heated to mixing temperatures, and agitated to prevent
settling. If you don't dispense the material after 1 nights use, you risk damaging the
material and possibly the machine due to settled material, which can harden in the
bottom of the material tank.
1 Attach each heater power cord to a suitable extension cord.
2 Attach each extension cord to its own outlet rated for 15 amps.
CAUTION
Attaching both heaters to the same outlet will most likely pop the circuit breaker
inline from the power source. Combining both heaters together will draw too much
amperage for most common 15 amp circuits.
WARNING
Suitable extension cord size requirements for 110 Volt use:
25-50 FT • 16-20 Amps • 12 Gauge (Heavy Duty) or 10 Gauge (Extra Heavy Duty)
100 FT • 16-20 Amps • 10 Gauge (Extra Heavy Duty)
Suitable extension cord size requirements for
220 Volt use:
25-50 FT • 8-10 Amps • 14 Gauge (Medium Duty) or 12 Gauge (Heavy Duty)
100 FT • 8-10 Amps • 12 Gauge (Heavy Duty)
Failure to use the correct size extension cord could result in damage and
possible fire!
3 Disconnect the heaters when using the machine’s burner system.
CAUTION
Do not use the heaters without heat transfer oil in the tank. Doing so will overheat
and damage the heaters, and they will have to be replaced.
Table 5-12 Overnight Heaters