CPT AUTOPILOT CPT, Руководство по установке

Страница: 9 / 32

CPT Autopilot Installation Manual
© 2018 CPT AUTOPILOT INC. VERSION 21 PAGE 7 OF 26
MOUNTING THE MOTOR BOX
(Only after the wheel pulley is mounted)
·
STANDARD PEDESTAL MOUNT (page 8): The Pedestal Bracket is designed to mount on most round (cylindrical)
pedestals. It comes in two sizes (shallow bracket for spoke-to-pedestal clearances from 2-3/4
ʺ to 3-3/4 ʺ , and deep
bracket for spoke-to-pedestal clearances over 3-3/4
ʺ
).
·
STANDARD PEDESTAL MOUNT WITH DROPDOWN PLATE (page 10): The dropdown plate lowers the motor
box below the pedestal bracket so that bracket doesn’t hit the base of the pedestal.
·
REVERSE-VERTICAL PEDESTAL MOUNT (page 12): If there is limited room below or aft of the wheel, a vertical
motor box is available that can be reverse-mounted forward of the wheel. The drive pulley faces forward instead of
aft; the motor rotation is reversed. The motor box may also be mounted with the drive pulley inside the perimeter of
the wheel if 1
ʺ spacers are used between the spokes and the wheel pulley. Due to increased leverage on the pedestal
bracket, it may require screws for mounting instead of hose-clamps.
·
L-BRACKET MOUNT (page 15): Mounting on a surface that is parallel to wheel shaft, such as a coaming, sidewall,
deck or cabin sole requires the L-bracket.
·
BULKHEAD MOUNT (page 17): The motor box bracket by itself can be used with appropriate shims to mount the
motor box assembly directly onto a console or bulkhead parallel to the boat's wheel. Teak or marine-board shims are
used to align the drive belt with the wheel.
·
TILTED WHEELS (page 19): The L-bracket is used to mount motor box on cockpit sole or cockpit side-wall for boats
with tilted wheels or slanted gear-driven wheels.
·
OVERSIZED WHEELS (page 19): The L-bracket is used to mount motor box to deck or sidewall in boats with large
wheels, or “deck-sweeper” wheels.
Shim
Shims can be used to obtain proper belt alignment between drive pulley and wheel pulley.
3"
2"
2" 2 ½"
Use #10 screws
(#7 or 3/16
ʺ
drill size)
Shim Dimensions