CPT AUTOPILOT CPT, Руководство по установке

Страница: 17 / 32

CPT Autopilot Installation Manual
© 2018 CPT AUTOPILOT INC. VERSION 21 PAGE 15 OF 26
L-Bracket Mount
1. Determine if the L-bracket is to mount on a sidewall or deck. Use
supplied bolts and nuts to attach the slotted motor box bracket so
slots will be vertical.
2. Use the clamping lever, washers, and knurled thumb nut to attach
the slotted motor box bracket to the fitting on back of motor box.
Lock the clamping lever when the slotted bracket is in the middle
of its adjustment range—centered in the slots.
3. Hold motor box roughly in position, and place the belt over the
wheel pulley and drive pulley. Place tape over the L-bracket
mounting area to enable marking. If any shims will be used, tape
them to the L-bracket.
4. Position motor box so belt is snug and both pulleys are aligned. To
check for alignment, hold a yardstick or straight-edge against the
back of the wheel pulley; it should be fairly parallel with the belt
when viewed from the side (clutch engaged and pushed in). Also
look from above the wheel and from the side to be sure the motor
box is square with the wheel from all directions and not at an
angle. If in doubt or the wheel is not uniform, favor a slight belt
slant that will help keep the clutch engaged.
5. Mark the location on sidewall or deck for the two ¼˝mounting
holes and around the base of L-bracket.
6. Drill holes for ¼˝ fasteners. Drill only one hole first and check fit
before drilling the second hole.
7. Use a backing block if the mounting surface is not substantial or
trustworthy.
8. If desired, use a mounting pad between the L-bracket and
mounting surface to ease clamp lever operation or to permit easy
removal of the L-bracket