PROGRAM INSTALLATION
8
Figure11-3) Set-up of your party’s ID 54321
2) You can call the party(ID : 54321) by pressing the “P” button and the Radio(ID :
54321) which received the call signal is operated by 2 methods as follows.
If the TX Radio is set up with (Repeater) + Destination + RADIO ID, the RX Radio
shows the party’s ID(12345) on the LCD.
But if the TX Radio is set up with (Repeater) + Destination, the RX Radio shows your
own ID(54321) on the LCD.
Even though your party’s Radio is in general mode, the Radio will be converted to
the call mode automatically after receiving a call.
(Figure 8-4) Display shown on the RX Radio when transmitting
with (Repeater) + Desti RADIO ID
3) After the call is completed, the Transmission and the Reception can be made by
PTT at the same method as normal call.
4) If pressing the “Enter” button for a long period (about 2 seconds), the release is
made with a Beep sound.
5) Also, if pressing and depressing the “M” button at the side within 2 seconds, the
release signal of 5Tone is transmitted.
8.4.2 Group(1:N) Call at call mode
1) In order to make the Group call at the call mode, the following should be set up at the PC
Programming.
2) If the 1
st
party(ID:13579) and the 2
nd
party(ID:12468) are in one group, the “1AAAA” which
is a call number / call name is allocated. (“A”means that all the numbers are applied.)
3)
If the caller makes a call to the 1
st
party & the 2
nd
party at the same time, the caller’s
Radio selects the parties with ID “1AAAA”and by pressing the “P” button on the Radio,
the 1
st
& 2
nd
party’s Radios display ID:1AAAA. After the call is completed, the
Transmission and the Reception have no restriction, which means that the RX/TX will be
free.
