InstroTek
43
Enter Nomograph material thickness in inches or mm,
depending on the unit already selected in the gauge. The
range of thicknesses that can be used with this function is 1 to
3.5 inches (25 to 90 mm). Do not use this function for thickness
outside this range, as the results will not be accurate.
Enter the density of the material immediately under the top
material. To obtain this density, use the gauge to measure the
material density prior to construction of the overlay.
Once bottom material density is entered, the Nomograph
mode can be activated. During measurements, “Nomograph”
is displayed to indicate Nomograph is active. If the gauge is
turned off, the Nomograph mode is disabled. Enable this
function again through the menu by following gauge prompts
and activating the most recent saved data.
The most recent Nomograph function inputs will remain in the
gauge until a new set of thickness and bottom density data is
entered for a new job.
Enter Material
Thickness: ## in
ENTER to Accept
ESC to Exit
Enter Bottom
Density: ## PCF
Enter to Accept
ESC to Exit