CPG 351S24(L/N), Руководство пользователя

Страница: 6 / 24

6
www.CookingPerformanceGroup.com
USER MANUAL
INSTALLATION INSTRUCTIONS
THESE UNITS ARE SUITABLE FOR INSTALLATION ON NON-COMBUSTIBLE
SURFACES ONLY. DO NOT INSTALL IT NEAR ANY COMBUSTIBLE SURFACES.
GAS CONNECTION
NOTE:
This device ships from the factory configured for areas whose altitude is lower than 6500 feet.
1. Ensure gas supply and gas type, as shown on unit nameplate agree. Unit installation must conform with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, the National Gas Installation Code, CSA-B149.1, or the Propane
Installation Code, CSA-B149.2 as applicable and in accordance with local codes.
2. A manual gas shut-off valve must be installed in the gas supply line ahead of the appliance and gas pressure
regulator for safety and ease in servicing.
3. The gas pressure regulator supplied must be installed on the appliance prior to connecting the equipment to
the gas line. Failure to install a regulator could be potentially hazardous and will void the appliance warranty.
4. Pipe threading compound must be resistant to the action of liquefied petroleum gases.
CAUTION:
DO NOT use an open flame to check for leaks. Check all gas piping for leaks with a soap and water
solution before operating unit.
Combustible Clearance Requirements: 6” sides, 6” back
Installation and service should be performed by a qualified installer who thoroughly reads, understands and
follows these instructions. If you have questions concerning the installation, operation, maintenance or service of
this product, visit Cooking Performance Group’s website at www.CookingPerformanceGroup.com.
Make sure that the floor where you plan to locate the oven is capable of supporting its weight along with any
accessories. Adequate clearance should be provided for proper operation and servicing.
Level the range once you’ve uncrated it in your facility using the adjustable feet.
Proper ventilation is crucial to safe and optimum performance. Ensure that the oven is installed underneath a
ventilation hood according to all applicable local and national codes.
Keep adequate clearance for air openings into the combustion chamber.