How to use
How to adjust the sensitivity of the particle sensor
When the product is shipped out, the pollution sensor is set to standard sensitivity. If the pollution level
stays at the highest level after 2 hours of operation or stays at the lowest level for more than 1 hour
when the air does not seem clean, users can adjust the sensitivity of the pollution sensor as follows.
1. While the product is operating, press the Power button and the
Mode button at the same time for more than 2 seconds.
2. The mode indicator flashes at an approximately 0.5 second interval.
3. Press the Mode button to adjust it to the desired sensitivity.
The mode indicator blinks as shown below once sensor sensitivity
has been selected.
SILENT
Level 1
Level 2
High
Standard
Low
4. Press the Power button and the Mode button at the same time for
more than about 2 seconds, the selected sensitivity will be inputted
and the product will start operating normally.
＊ If the Power button and the Mode button are not pressed for 10
seconds, the selected sensitivity of the sensor is automatically
entered.
2 sec.
2 sec.
Flash
ADJUST PARTICLE SENSOR
ENGLISH / 14
