To comply with RF exposure requirements, a minimum separation distance of 80cm and with
80 cm
PRECAUTIONS
Observe the following precautions to prevent fi re, personal injury, and transceiver
damage.
• Do not attempt to confi gure the transceiver while driving; it is too dangerous.
• Do not disassemble or modify the transceiver for any reason.
• Do not expose the transceiver to long periods of direct sunlight, nor place it near heating
appliances.
• If an abnormal odor or smoke is detected coming from the transceiver, switch the
transceiver power off immediately, and contact your
COVALUE
dealer.
• Use of the transceiver while you are driving may be against traffi c laws. Please check
and observe the vehicle regulations in your area.
• Do not use options not specifi ed by
.
◆
The transceiver operates in 12 V negative ground systems only! Check the battery polarity and
voltage of the vehicle before installing the transceiver.
◆
Use only the supplied DC power cable or a
optional DC power cable.
◆
Do not cut and/or remove the fuse holder on the DC power cable.
For passenger safety, install the transceiver securely using the supplied mounting bracket and
screw set so the transceiver will not break loose in the event of a collision.
COVALUE
COVALUE
Antenna substitution:
Do not substitute any antenna for the one supplied
or recommended by the manufacturer or radiodealer.
Youmaybe exposing personor persons to excess radio frequency radiation.
Youmay contact your radio dealeror themanufacturer for further instructions.
Maintain a separation distance from the antenna to person(s) of
at least
, 50% duty Cycle.
ìThis transmitter is authorized to operate with a maximum duty factor of 50%,
in
typical push-to-talk mode, for satisfying FCC RF exposure compliance requirements.î
a 2dB cable loss is required between antenna and all public persons.
