4. Press
/
to view each member on the list.
▲
Scan
When you start a scan, your radio cycles through the programmed scan list looking for voice activity. The LED blinks
Orange while in scan mode. During a dual mode scan, if you are on a digital channel, and your radio locks onto an
analog channel, it automatically switches from digital mode to analog mode for the duration of the call. This is also true
for the reverse.
There are two ways of initiating scan:
• Main Channel Scan (Manual): Your radio scans all the channels/groups in your scan list. On entering scan, your
radio may, depending on the settings, automatically start on the last scanned “active” channel/group or on the
channel where scan was initiated.
• Auto Scan(Automatic): Your radio automatically starts scanning when you select a channel/group that has Auto Scan
enabled.
□
Starting and Stopping Scan
Procedure:
Press the programmed Scan button to start or stop Scan.
OR
Follow the procedure below.
1. Use the Channel Selector Knob to select a channel programmed with a scan list.
2. Press
to access the menu.
3. Press
/
to Scan and press
to select
4. The display shows Turn On if scan is disabled.
OR
The display shows Turn Off if scan is enabled.
5. Press
to select. The LED blinks orange when Scan is enabled. Or the LED turns off when Scan is disabled.
□
Responding to a Transmission During a Scan
During scanning, your radio stops on a channel/group where activity is detected. The radio stays on that channel for a
