Step 5:
Slide the canopy/frame connectors (#31) onto
the U-shaped side canopy braces (#7) and
fasten into position by using screws (#16).
Make sure that the teeth on the canopy
connectors are facing towards the inside of the
swing. See Fig. B – Step 1 and Step 2.
PAGE 3 OF 7
Fig. A
Fig. B
Note:
When fastening with bolts and nuts, always use
a washer (#22 and #23) between the tube and
the bolt and the tube and the nut.
Step 1:
Fasten the front and rear upright support (#2
and #3) at the top, by using bolts (#17),
washers (#22), and plastic nuts (#25). Repeat
the same procedure for both sides. Do not fully
tighten the plastic nuts and bolts yet.
See Fig. A – Step 1.
Step 2:
Attach the top cross beam w/adjustable teeth
(#1) to both ends of the upright supports (#2
and #3). See Fig. A – Step 2.
Step 3:
Fasten the lateral cross braces (#4) to the
uprights supports (#2 and #3) by using bolts
(#18), washers (#23), and plastic nuts (#27).
See Fig. A – Step 3.
Step 4:
Fasten the rear cross brace (#5) to the rear
upright supports (#3) by using bolts (#18),
washers (#23), and plastic nuts (#27). Insert
the leg caps (#33) into all of the base feet.
Tighten all of the plastic nuts and bolts.
See Fig. A – Step 4 and Step 5.
Step 1
Step 2
Step 3
Step 5
STOP
DON’T RETURN TO STORE!
22
2
2
18
33
33
7
7
16
16
23
23
29
27
2
2
2
3
3
3
3
4
4
1
3
22
28
28
22
22
25
25
17
17
Do not tighten bolts
after Step 1. Fasten
all bolts after Fig A.
Step 4
18
23
29
27
3
3
5
23
Step 1
Step 2
31
