Installing the head assembly
4-5
Step 4 - Secure head assembly and filler panel
Push down on the cable assemblies, and
the head assembly to ensure they are
fully seated and that there are no gaps.
All assemblies fit tightly and may require
extra downward force to ensure they are
fully seated.
Using a T25 Torx driver, secure the head
assembly to the body by tightening its two
captive security screws.
Then tighten the two captive screws on
the filler panel.
IMPORTANT!
Tighten screws only
until snug (approximately 15 in-lbs). Do
NOT overtighten.
Tighten the two
security screws
on the head
assembly
Tighten the two
screws on the
filler panel
