15
14.2
14.1
15.1
13.1
13.2
13.3
13.4
13
14
MOTION
CM-09/10 ELECTRONIC TUBULAR MOTOR
MOTION
CM-09/10 ELECTRONIC TUBULAR MOTOR
Move the blind to a desired favourite position.
Press the
program
button on the motor to activate
program mode. The blind starts stepping.
Hold the
centre
button to save this favourite position. The blind shortly
stops stepping indicating the favourite position has been saved succesfully.
Press the
program
button on the motor to de-activate
program mode. The blind stops stepping.
Press the
program
button on the motor to activate
program mode. The blind starts stepping.
Hold the
program
button until the blind stops stepping (approximately 5 seconds)
to de-activate or re-activate direct control.
When pressing the up or down button on the remote control the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be de-activated. Now, the blind only directly moves to its end
positons when the up or down button is held longer than two seconds.
It is possible to only delete end limits or to do a default factory reset.
A default factory reset will delete the end limits and remove the connection to any paired
remote.
Press the program button on the motor to activate program mode.
Delete end limits:
To delete the end limits of the blind hold the
program
button
until the blind stops stepping for the first time, keep holding the button until the
blind stops stepping for the second time. (approximately 10 seconds)
Default factory reset:
To reset the blind to the default factory setting hold the button for at least 20
seconds.The blind will stop stepping twice. After the second stop the blind will give one extra step to
confirm the default factory reset.
Centre
Reset favourite position
De-activate direct control
Reset the blind
EnglishEnglish
