11
EN
G
LI
SH
Choke on
Choke off
3
4
1
2
Stop
Start
5
8.1 Cold- starting the engine
Cut the trimmer wires to a length of about 13
cm before starting, to avoid overloading dur-
ing the warm-up.
1. Place the grass trimmer on a hard, flat
surface.
2. Press the safety lock (1) and the throttle,
then press the throttle on the side of
the handle so that the throttle remains
pressed.
3. Push the stop button backwards (from the
”STOP” position).
4. Turn the choke switch upwards to activate
the choke function (turn off the choke
damper).
5. Press the primer pump a few times (the
primer pump is found at the underside of
the carburettor).
6. Pull out the start handle until you feel a
resistance, and swiftly, yet gently pull it
4 to 5 times (do not pull out the whole
string when attempting to start the
engine).
7. When the engine is turned on, turn the
choke switch to the open position. If
the engine stops working, pull the start
handle again with the choke switch in the
closed position.
8. Let the engine operate without a load for
10 seconds after starting it.
8. Warm- starting the engine
1. Place the grass trimmer on a hard, flat surface.
2. Press the safety lock and the gas control, then press the gas lock from the inner
side of the handle so that the gas remains pressed.
3. Push the stop button backwards (from the ”STOP” position).
4. Bring out the start handle until you feel a resistance and then pull it swiftly, yet
gently until the engine is turned on.
8. Turning off the engine
Release the throttle, let the engine run on empty and move the power switch into the
“STOP” position.
Содержание 30-9405
Страница 63: ......