Cotech 18-3083, Инструкция по эксплуатации

Страница: 8 / 36

8
EN
G
LI
S
H
Operating Instructions
Forward/reverse
• Choose desired tool (screwdriver bit, drill, etc.), insert it into the quick chuck
and tighten.
• The machine is started and stopped by holding or releasing the power switch.
To change the direction of rotation, release the power switch and move the
selector to the desired setting.
• The chuck spins clockwise if you hold the forward/reverse selector (4) on the
left side, and anticlockwise if you hold it on the right side.
• Set the forward/reverse selector to the middle position when the machine is not
being used.
Setting the torque
• The machine has a clutch for adjusting the torque setting (2). At the correct
torque setting the clutch releases, preventing the screw from going in too
deeply.
• The torque setting depends upon the type of screw, its size and the type of
material used. Always start on a low torque setting and increase in stages until
the desired result is achieved.
2