9. After installation on the left
side, then insert right side of the
roller bar into A2 hole, and then
tighten the bolts
on A2
by wrench.
8. Then insert the left side of the roller bar into A1 hole.
3. Make sure that the bolts are firm in place, yet let them stick out of the wall
approximately 2.5 cm or less-enough that the wall bracket can be installed
onto them. Firmly tighten the bolts with a 19 mm hex key. It is best to use the
hex key with a closed end rather than an open end to avoid damaging the nut,
should it slip.
14
Bolt
M10X80MM
7.Please assemble the A1 on the wall by first, tighten the bolts by wrench.
And assemble the A2 on the wall but do not tighten the bolts very much
until step 9.
