9
www.costway.com
8
www.costway.com
3.8 Install indicator diagram
1.)gun hook assembly ;
2.)Quick connector structure on the machine body . All the Accessories can be storaged on the
machine .
4. After use instructions
The machine should be stored in a frost-free room!
Pump, hose and accessories should always be emptied of water prior to storing as follows:
Stop the machine (press the start/stop switch “O” and detach water hose, high pressure hose
and nozzle
Restart the machine and activate the trigger of the trigger gun.
Let the machine run until no more water runs through the trigger gun.
Stop the machine, unplug and wind up hose and cable.
Place trigger gun, lance, nozzles and other accessories in the holders of the machine.The hook
can be used for storage of the hose and cord.
All accessories can be stored in the washer after using.
WARNING:
Never start up a frozen machine. Frost damages are not covered by the guarantee!
5. Environmental protection
Old appliances contain valuable materials that can be recycled. Please arrange for the proper
recycling of old appliances. Please dispose of your old appliances using appropriate collection
systems.
3.5 Start/stop of the machine
The trigger gun and lance is affected by a thrust during operation - therefore always hold it
firmly with both hands.
IMPORTANT:
Point the nozzle at the ground.
Check that the machine is in upright position. NOTE: Do not place the machine in high grass!
Release the trigger lock .
Activate the trigger of the trigger gun and let the water run until all air has escaped from the
water hose.
Press the Start/stop switch .
Activate the trigger of the trigger gun .
Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be
cleaned.
Do not cover the machine during operation or use it in a room without adequate ventilation!
NOTE:
If the machine is left or not used for 5 minutes, it must be switched off on the start/stop
switch "O":
Press the start/stop switch "O".
Disconnect the electrical plug from the socket.
Shut off the water supply and activate the trigger of the trigger gun to relieve the machine of
pressure.
Lock the trigger gun
When releasing the trigger of the trigger gun , the machine automatically stops. The machine
will start again when you re- activate the trigger gun
3.6 Multi Nozzle
The pressure for the multi nozzle can be adjusted by turning it.
WARNING: Do not do this under operation to avoid that the
hand hits the jet.
3.7 Use of built-in detergent bottle
1. Unscrew the lid built-in detergent bottle.
2. Add detergent to Built-in detergent bottle.
3. Replace the nozzle of the spray gun to the detergent nozzle as below:
4. And then spray detergent.
