3.2 Mounting of high pressure hose
Attach the high pressure hose to the trigger gun and
machine.
Detach the high pressure hose by pressing the pawl (A) or
button (B)
3.3 Mounting of lance and nozzle
Push the lance into the trigger gun
When inserted turn it. Caution: Make sure the lance is properly fixed to the gun
Attach the nozzles. Caution: When attaching the nozzle the button (A) on the nozzle should
come out again. Check before activating the trigger that the nozzle is properly fixed.
Attention: All accessories nozzle can be installed as above instruction
.
3.4 Water connection
Connecting the water supply pipe
Follow your water supplier’s instructions .
For connection information, see the data plate/technical specifications
Use a reinforced hose (not supplied) with a standard connection (ext. diameter: 16mm/int. 12mm,
maximum length: 25m).
IMPORTANT!
Only use water without any impurities. If there is a risk of sand particles in the inlet
water (i.e. from your own well), an additional filter should be mounted.
Let the water run through the water hose before connecting it to the machine to prevent sand and
dirt from penetrating the machine. Note: Check that the filter is fitted in the water inlet pipe and
that it is not clogged up.
Connect the water hose to the water supply by means of the quick connector (inlet water, max.
pressure: 10 bar, max. temperature: 60°C).
Turn on the water.
7
www.costway.com
6
www.costway.com
Contents
1. Gun nozzle
2. Gun lance
3. Gun handle
4. High pressure hose
5. Outlet connector
6. Machine body
7. Hose reel
8. Power cable
9. Plug
10. Inlet hose
11. Water tap
2. First time instructions
This section will explain in details how to make high pressure washer ready for use.
SAFETY DEVICES
•
The unloader valve can reduce pressure if it exceeds pre-set values.
Locking device on trigger gun (see illustration at the beginning of this
manual): The trigger gun features a locking device. When the knob is
activated, the trigger gun cannot be operated.
THERMAL SENSOR
A thermal sensor protects the motor against overloading. The machine will
restart after a few minutes when the thermal sensor has cooled.
3. Operation instructions
3.1 Connection of garden hose
Screw the water inlet coupling (10) tight on to the water inlet
Note: The inlet filter (A) must always be fitted in the water
inlet pipe to filter out sand, lime stone and other impurities as
these will damage the pump valves.
Caution: Failure to fit the filter will invalidate the guarantee
Connect the garden hose with a standard quick coupling
