
MODEL
“L”
“W”
“D”
“H”
“A”
“B”
SEE ILLUSTRATION C
LENGTH
WIDTH
HEIGHT
TO DECK
HEIGHT
TO LIP
DRAIN LOCATION
DRAIN LOCATION
507190
60”
36”
22 1/2”
21”
9 1/2”
18”
507187
58”
38”
23 1/2”
22”
9 1/2”
19”
507193
60”
60”
21”
19 1/2”
27 1/4”
20”
Deck to floor dimensions are measured through the drain hole to give a more consistent measurement. The
dimensions were achieved by laying a straight edge across the deck, the distance was then measured from
the floor at the drain opening to the bottom of the straight edge. (See illustration D). The lip height is then
subtracted to give a more consis tent floor to lip height. There may be height dimension variations of plus
minus ¼” from the stated dimension in the table, which is a standard production tolerance.
A
B
L
W
D
H
Illustration C
W
L
B
L
W
A
A
B
Illustration D
HEIGHT TO LIP
MEASURE FROM
STRAIGHT EGDGE
TO
FLOOR THROUGH
DRAIN
HEIGHT TO DECK
TAPE MEASURE
STRAIGHT EDGE OR WOOD BOARD
Illustration E
12”
11”
DRAIN CLEARANCE
PUMP ACCESS
DRAIN CLEARANCE
MEASURE FROM THE FLOOR TO
THE STRAIGHT EDGE THROUGH
THE DRAIN HOLE TO OBTAIN A
CONSISTENT HEIGHT TO DECK
DIMENSION
INSTALLATION PLANNING AND PREPARATION
1.
BATH TUBS MUST BE SET IN SETTING COMPOUND.
An uneven floor can impede installation.
2.
NEVER LIFT THE TUB BY THE PLUMBING
. Doing so can result in leaks.
3. Check if the floor is level and of good quality. An uneven floor may impede proper installation of the
product. The floor structure must be capable of supporting a minimum of 100 pounds per square foot.
a. Clean the area of any debris or trash.
b. Use a 5 or 6-foot level to determine if the floor is level. If not, calculate the amount of mortar required to
level the tub.
c. Insure that the drain rough is placed at the proper location.
d. Check if the proper electrical service has been installed near the pump location. See electrical
requirements for specifications.
4. If this is a deck installation, measure from the floor to the bottom of the rim to ensure that the tub is not
suspended by its rim.
The entire tub floor must be fully supported.