UNPACKING THE UNIT
1. Inspect the carton.
2. If you note carton damage, take a picture if possible and contact the deliverer.
3. Inspect the unit immediately for damage even if there is no visible carton damage. The installer is
responsible for damage that occurs once the unit is placed in its assigned location. Once the unit is
installed and surface damage is visible, we will assume it was caused by the installer if you do not report it
immediately.
4. Inspect the plumbing for any loose fittings.
5. On whirlpool units the unions on the suction and discharge sides of the pump have been color marked to
indicate the alignment that was present at the factory water test. If these are not aligned, retighten and test
for water tightness.
6. Remove all packaging material except for the protective plastic. It was placed on the tub at the factory to
eliminate abrasions from handling. It should only be removed at the final clean up.
Estate Collection Electrical Requirements
1.
ALL CONNECTIONS MUST
BE GFCI (Ground Fault Circuit
Interrupted) PROTECTED
2. Whirlpool, and Total Massage
units require dedicated 20 amp,
120 volt service.
3. You must provide a receptacle
with a 20-amp configuration.
4. See local codes for proper wire
size, if not specified, use #12
Copper only wire.
IMPORTANT SAFETY INSTRUCTIONS:
WARNING! WHEN USING THIS PRODUCT, YOU SHOULD ALWAYS FOLLOW BASIC PRECAUTIONS.
READ AND FOLLOW ALL INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY.
•
DANGER:
To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised.
• Use this unit only for its intended purpose as described in this bulletin. Do not use attachments that are not
recommended by the manufacturer.
• Never drop or insert any objects into any openings.
• The unit must be connected to a circuit interrupter (GFCI) provided by the installer. The (GFCI) breaker
should be tested on a routine basis. To test the (GFCI) breaker, push the test button. The GFCI should
interrupt power. To restore power, push the RESET button. If the GFCI fails to operate in this manner there
is ground current flowing, indicating the possibility of an electrical shock. Do not use the unit. Disconnect
the unit and have the problem corrected by a qualified service representative before using.
• DANGER: RISK OF ELECTRICAL SHOCK. All pumps must be connected to a ground fault circuit interrupter
(GFCI) protected outlets. Standard Line Total Massage units can be operated on a single service.
PUMP
120V/20AMP
MALE PLUG
WHIRLPOOL CIRCUIT WITH AIR ON/OFF SWITCH
AIR SWITCH
Illustration A
ON/OFF PUMP
8.8 AMP
OUTPUT INTPUT
UP/HAUT
W/D KEYPAD
TMS-P/TIMER
CONTROL
PUMP FLOW
CONTROL VALVE
0.5 AMP
PIGGY BLOWER
7.5 AMP
OUTPUT INTPUT
UP/HAUT
W/D KEYPAD
GROUND
TMS-VARIABLE
CONTROL
JUNCTION BOX
120V/20AMP
MALE PLUG
TOTAL MASSAGE CIRCUIT
OPTIONAL JUNCTION BOX, IF NOT
AVAILABLE USE TWO 20AMP
CONNECTIONS
Blower
Speed
Wave
Jets
Speed
Wave
Illustration B
