Costar CR1000INR, Руководство пользователя

Страница: 10 / 23

User’s Manual
4
2.3 Rear Panel
Network Port
Audio In/Out
RS485 Port
Video Out (BNC)
Video Out (VGA)
Power In

Network Port:
Connect a Cat5 cable with an RJ-45 jack. Refer to the INIT User’s Manual for details
on network connection setup.

Audio In/Out:
Connect to an audio source (line-in or microphone) and an amplifier (line-out) by using
a Y-connector (red: audio out, white: audio in) provided with the receiver. The receiver does not have
amplified audio output, so you will need a speaker with an amplifier.
 RS485 Port: Connect to a device for RS485 communication. Connect TX+/RX+ and TX-/RX- of the
device to the + and – (respectively) of the receiver. Refer to the device’s manufacturer’s manual for the
RS485 connection configuration.
 Video Out (BNC): Connect a monitor.

Video Out (VGA):
Connect a VGA monitor.
 Power In: Connect the power adapter (5 VDC, 0.8A). The receiver starts booting as soon as power is
applied.
NOTES:
 It is possible that the receiver will not detect a VGA monitor automatically if the connected VGA monitor
does not support the auto detect function. In this situation, switch the video output to VGA out. See
Chapter 3 – Remote Setup; 3.4 Video, Display for details on switching video output.
 Camera and audio surveillance may be prohibited by laws that vary by region. Check the laws in your
area before using this product for surveillance purposes.
CAUTION: The network connector is not designed to be connected directly with cable or wire
intended for outdoor use.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD. MAKE
CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY FURNITURE. DO NOT
INSTALL POWER CORDS UNDER RUGS OR CARPET. THE POWER CORD HAS A GROUNDING
PIN. IF YOUR POWER OUTLET DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT
MODIFY THE PLUG. DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES
INTO ONE CIRCUIT.