Costar Video Systems CDI2110VIRFH, Руководство по установке

Страница: 12 / 26

Part 1 – Introduction
12
•
Dome Cover Screw Hole
Secures the dome cover to the camera.
• Factory Reset Switch
Restores the camera's default factory settings. For
more information, refer to the
Factory Reset
.
• SD Memory Card Slot
Used to insert a microSD memory card into
the camera. (An SLC (Single Level Cell) or MLC
(Multi Level Cell) card by SanDisk or Transcend is
recommended) For more information, refer to the
Inserting a SD Memory Card
.
• Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
• An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.
• Rubber
Do not remove the rubber.
•
Side Cable Access Hole
For routing cables and wires.
• Bottom Cover
Allows you to install the camera on a wall or a ceiling.
•
Heater
A built-in heater that enables normal operation in
sub-zero temperature conditions.
Heater supported model only
Requires a 12 VDC power source.
•
Bottom Cover Securing Point
Align this reference point with the dome cover's
reference point to assemble them.
•
Ceiling Cable Hole
The cables and wires from the device can lead to the
ceiling through this hole.
Factory Reset
Only use the factory reset switch to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Cut off power.
2
Press and hold the reset switch using a thin object
such as a pin, and resume power supply.
3
Release the reset switch 5 seconds after the device
turns on.
4
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
It's also possible to do a factory reset by pressing
and releasing the reset switch while the camera is
turned on or using the INIT program from a remote
location. A factory reset will reboot the system. For
more information on factory reset, refer to the
INIT
operation manual
.