21
with a soft cloth.
· After having carefully checked that the display case is completely dry inside, start the appliance again by the wall
cut-out switch.
· Allow a couple of hours before loading the products back again.
4) Every six months clean the honeycomb in the following way (fig. 16 - page 7):
a) loosen the screws fixing the support;
b) remove the honeycomb;
c) use a jet of hot water (max. 70°C) to remove any dust which may have built-up on honeycomb ducts;
d) dry with a jet of air;
e) replace the honeycomb with great care.
Attention! Disassemble and assemble very slowly, using heavy-duty gloves. It is advisable to have these clea-
ning operations carried out by authorized service personnel.
ANY MAINTENANCE OPERATION NOT INCLUDED AMONG THE FORMER STEPS MUST BE CARRIED OUT BY THE
AUTHORISED AFTER-SALES SERVICE OR BY QUALIFIED PERSONNEL.
CANOPY AND SHELF LIGHTING: canopy and shelf lamps must be replaced by the after-sales service only. Resort to
it if need be.
If you should wish to eliminate shelf lighting, let it be done by the authorised after-sales service.
11. EMERGENCY SITUATIONS
1) The display case will not start or will not keep on working:
• there may be a general black-out;
• the wall main switch may be off.
If power failure is not due to any of the above causes, call the nearest after-sales service immediately, empty
the display case and store the foods in coldrooms or refrigerators that may ensure preservation temperature.
2)
The display case will not cool properly:
• make sure that the product load is correct and the air slots are not covered;
• defrost and clean it before starting normal operation (see chapter 10);
• make sure that the case is not exposed to sources of heat or draught;
• check that the display case is perfectly horizontal by the use of a spirit level. Make certain that ambient conditions
comply with the requirements of page 4.
Should insufficient cooling persist, resort to the nearest after-sales service.
3)
The cabinet operates noisily:
• Make sure that screws and bolts are closed tight;
• Check that the display case is perfectly horizontal by the use of a spirit level.
IN CASE OF A GAS LEAK OR FIRE, do not breathe inside the room that houses the display case before having aired
it properly. Turn the display case off by the main switch ahead (see Fig. 17). DO NOT USE WATER BUT ONLY DRY
EXTINGUISHERS TO FIGHT THE FIRE.
12. AFTER-SALES SERVICE
Should it be necessary to resort to technical assistance, contact your sales person immediately. If spare parts are nee-
ded, always refer to your after-sales service:
insist on the use of original spare parts.
Scroll the Italian and
European network of branch offices on the back of this manual for addresses and phone numbers.
