Cosmos XA-4200IICH, Инструкция по эксплуатации

Страница: 23 / 48

- 20 -
(B) Setting
Enter the user mode (page 16), and take the following steps.
1) While [SET UP] is displayed, press the [ AIR ADJ.] and [ POWER] buttons
simultaneously.
2) Press the [ AIR ADJ.] button to cycle through the following options: [BUZZ]
(Audio on/off), [VOL] (audio volume), [CLK] (clock adjustment), and [LONG]
(battery saving mode).
3) See below for the setting procedure for each option.
(B-1) Audio on/off
1) While [BUZZ] is displayed, press the [ AIR ADJ.]
and [ POWER] buttons simultaneously.
--> The current status (ON or OFF) will be displayed.
2) Press the [ AIR ADJ.] button to switch between the ON
and OFF options. Select ON or OFF.
--> The selected option (ON or OFF) will be displayed.
3) To confirm the selection, press the [ AIR ADJ.] and
[ POWER] buttons simultaneously.
--> “SAVE OK?” will be displayed.
4) To save the selection. press the [ AIR ADJ.] and
[ POWER] buttons simultaneously
--> When ON is selected, the unit will beep twice and the
audio mute icon will be hidden, when OFF is selected,
the unit will not beep and the audio mute icon will
be displayed. The LCD will then return to the [BUZZ]
display.
5) To continue adjusting settings, press the [ AIR ADJ.]
button and select the next item. (page 20 “(B) Setting”)
6) To exit the user mode, press the [ POWER] button
repeatedly until the LCD returns to the <gas concentrations>
screen.
--> When the audio is set to OFF, audio mute icon is
displayed on the <gas concentrations> screen.
MENU
MENU
MENU
MENU
MENU
▲
▲
▲
▲
▲
▲
▲
<Battery saving mode> <Audio on/off>
▲ ▲ ▲ ▲
<Audio volume> <Clock adjustment>
(Audio is ON)
<OFF is selected>
(Audio mute icon
when audio is OFF)
(Audio mute icon
displayed when
audio is off)
Audio on/off setting will be saved even after the unit is turned
off or the battery is removed.
WARNING
- 19 -
4) To change the alarm volume, press the
[ AIR ADJ.] button.
--> The volume level can be changed
in three steps.
5) To confirm the change, press the [ POWER] button.
6) To continue the alarm test, repeat the steps from 2) to 5).
7) Press the [ POWER] button.
--> The LCD will return to the [AL TEST] display.
8) To go to a different mode, press the [ AIR ADJ.] button for mode selection.
--> Press the button to cycle through the following modes: [AL TEST] (alarm test),
[SET UP] (settings), and [LOG] (logging).
9) To exit the user mode, press the [ POWER] button
repeatedly until the LCD returns to the <gas concentrations>
screen.

The factory default for alarm volume level is 3.
 The change of audio alarm level should be performed by the
safety manager. If the level is changed, make sure to check by
an alarm test.
MENU
(Returns to AL1 for
1 st stage alarm)
MENU
<Gas concentrations>
WARNING
▲
▲
<Alarm test> <Logging>
<Settings>
･
Audio on/off
･
Audio volume
･
Clock adjustment
･
Battery saving mode
▲
▲
▲
Alarm volume level
MENU