Remove all items from tray, grab outer ends and squeeze together,
push up and pull out the tray.
Wash tray and install back in place or adjust height as desired.
Maintenance & Care
Overall Cleaning
To maintain proper cooling and preserve energy, clean the dust from
behind and under the refrigerator regularly. The inside should be clean
regularly as well to avoid odors and bacteria from forming. Use a soft
towel or non abrasive sponge with soapy water to clean.
The freezer should be cleaned with clean water and dry cloth. Leave
the doors open for natural drying before restoring power to the unit.
Do not use hard brushes, steel wool, wire brushes, abrasives such as
toothpaste, organic solvents (alcohol, acetone, banana oil, etc.) boiling
water, acid or alkaline items to clean the refrigerator. Doing so may
damage the fridge surface and interior.
Do not rinse with water or you could affect the electrical insulation.
Cleaning of Door Trays
(The picture above is for reference only. The actual configuration
will depend on the physical product or statement by the distributor)
Grab front edge of shelf and tilt up until lower end of fixed leg comes out of support.
Lift the shelf up as far as you can (in slot).
Please dismantle the cantilever shelf according to the arrows shown above:
During installation, put the upper end of the fixed leg into one of the upper
slots on the supporting iron first, then put the lower end of the fixed leg into
the third slot on the lower part of the supporting iron.
Cleaning of lower freezer drawer
Pull shelf out towards you (horizontally)
button
Pull out the lower freezer drawer towards you
As shown above; press the buttons in both slots at the same time and pull drawer
out until it stops.
Pull the drawer up and out as shown.
After cleaning, put the drawer back in the original position, close the drawer and
the button mechanism will lock it automatically.
Note: do not remove the lower freezer drawer if not necessary.
Cleaning the Shelf
To replace the shelves:
1. While tilting the shelf up,
insert the top hook at the
back of the shelf in a slot on
the track.
2. Lower the front of the
shelf until the bottom of the
shelf locks into place.
18
19
