14
15
4
Take out the fabric filter.
The inside of the dishwasher is self-cleaning under normal use. If needed, the
tub gasket can be cleaned with a damp cloth. Use a brush to clean the opening
in the end of the gasket.
Cleaning the air gap
If there is an air gap installed with your dishwasher, make sure that it is clean so the dishwasher will
drain properly. The air gap is not part of your dishwasher.
Before you clean the air gap, turn off the dishwasher, then remove the plastic air gap cover and clean
with a toothpick.
Protecting your dishwasher for long periods of non-use
Your dishwasher should be protected from freezing if you plan to leave it for extended periods in an
unheated place. Have a qualified person do the following:
To disconnect service:
1
Turn off the electrical power to the dishwasher at the supply source by removing fuses or tripping
the circuit breaker.
2
Turn off the water supply.
3
Place a pan under the inlet valve, then disconnect the water line from the inlet valve and drain it
into a pan.
4
Disconnect the drain line from the pump and drain the water into a pan.
To restore service:
1
Reconnect the water, drain, and electrical power.
2
Turn on the water and electrical power supply.
3
Fill the detergent cup and the rinse aid cup and run the dishwasher through a heated-wash cycle.
4
Check all connections to make sure that they do not leak.
5
Flush the filters by holding
them under running water.
6
Replace the fabric filter.
7
Replace the fine filter.
8
Replace the cylinder filter.
9
Replace the bottom rack.
Cleaning the door and tub gaskets
Clean the door gasket with a damp cloth to remove food particles regularly.
